Welding Safety Glasses
Visible Light Transmission for each lens shade: Shade 2 = 20-28%, Shade 3 = 10-14%, Shade 5 = 2-4%
Welding goggles provide a degree of eye protection while some forms of welding and cutting are being done. They are intended to protect the eyes not only from the heat and optical radiation produced by the welding, such as the intense ultraviolet light produced by an electric arc, but also from sparks or debris.[1] A full facemask may be required for arc welding. Welding Glasses,Welding Safety Glasses,Auto Darkening Welding Glasses,Welding Gas Protective Glasses Changzhou Edaweld Trading Company Limited , https://www.edaweld.com
Welding Safety Glasses help protect welders against Photokeratitis, also known as "welder's flash." Welding Safety Glasses are designed with Shade 3 or Shade 5 Lenses and are primarily used for torch soldering, brazing and cutting. Welding Safety Glasses are not intended for arc welding, which requires a darker lens found in Welding Helmets (OSHA's 29 CFR 1910.252 lists the minimum lens shade requirements for a variety of welding operations).
Welding and cutting processes, including arc welding and cutting, as well as brazing produce intense ultraviolet (UV), infrared (IR) and visible light wavelengths. The UV and IR wavelengths cannot be seen and can produce eye injury without the victim realizing it immediately. Extremely dark filters of the proper sort are needed for the welder to be able to look at the intensely glowing metal being welded. An approved face shield or welding helmet can also have filters for optical radiation protection, and offer additional protection against debris and sparks.[2] UV blocking protective spectacles with side shields or welding goggles are considered primary protection, with the face shield or welding helmet considered secondary protection.[3] This way, the eyes are still protected even when the face shield or helmet is lifted up.[4]
The optical filter in welding goggles, face mask or helmet must be a type which is suitable for the sort of work being done.[5] A filter suitable for gas welding, for instance, should not be used for arc welding. Face masks which are self dimming are available for arc welding, MIG, TIG, and plasma cutting, and allow better vision before the arc is struck and after it is extinguished.[6] Failure to use such protection when arc welding or even being near where arc welding is going on can result in a painful condition called [arc eye" or photokeratitis, which is akin to a severe sunburn of the cornea and conjunctiva of the eye.
Yangzhou Liugong New 20t Medium and Deep Well Drilling Machine Successfully Developed